We have about 40 sets out in the field at this point and the feedback has been very positive,” says Zimmerman. “We found that these springs worked best with the slight progressive rate in order to absorb the hit from the tire and then as more force is applied to the tire, they settle in to keep the tire stuck to the racing surface. Over ten years of Team Z’s research and development have been used to make a spring package that simply works.Ī slightly-progressive rate along with a proprietary blend of spring steel (like that used in racing valve springs) combines to keep the tires planted downtrack. In fact, Zimmerman has tested them on his own car, “ Blackie“, which has achieved an insane 1.17 best short time using these springs and the company’s Strip Series control arm package along with an anti-roll bar. They’ll lower the ride height approximately 1.5 to 2 inches depending on vehicle weight, and will drastically improve the geometry and 60-foot times. These made-in-the-USA springs work in the stock location and are designed to replace the stock springs on a 1979-’93 Mustang. So what did he do? He decided to design a spring that would work properly and not break the bank for his customers. We found the cut-coil V8 spring to work most effectively with the anti-roll bar, but most people couldn’t find a set of stock springs that weren’t worn out,” he explains. Some of the spring kits in the market have left and right rear springs that have different rates, but those were designed years ago when people weren’t using anti-roll bars. “For years, I’ve been advocating that if someone wants to stick with the stock rear suspension design, that they take a factory V8 spring and cut off one coil – and that’s been good enough. Zimmerman has been designing suspension parts for the Mustang for over a decade now, and his front K-member kits and rear suspension kits are found on some of the quickest and fastest Mustangs in the small-tire racing scene. The factory coil springs are acceptable, but not ideal for a racing application, and that’s where Dave Zimmerman and the crew at Team Z Motorsports comes into the picture. Now, I understand that some people cannot identify quality even if they trip over it so for them, they will be contempt with running sub standard parts.The Fox-chassis Mustang boasts one of the most successful factory-designed rear suspension systems for drag racing that has ever graced the pavement. Simply put, the Maximum Motorsports K member is the best one available and that is why i installed it on my Mustang. Additionally, a k member that flexes also has a negative effect on ride quality. After all, the factory K member is a life time part. Plus, A K member should be a lifetime part that will last the life the car rather than a race piece that will need frequent inspections and eventually get timed out. You are right, I only use the best parts on my Mustang and for the reasons I mentioned, the Maximum Motorsports K member is the best one available because Maximum Motorsports unlike other mustang suspension companies understands that building the lightest possible K member is a mistake due to the fact that in addition to engine torque, a k member must take braking and cornering loads without deflecting and the light weight drag race k members deflect more than the stock one does.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |